Call us: +91 - 9811593007

WHY CONSTANT VOLTAGE REGULATOR

We manufacture Constant Voltage Regulators which use a tank circuit composed of a high-voltage resonant winding and a capacitor to produce a nearly constant average output with a varying input. The constant voltage regulator approach is attractive due to its lack of active components, relying on the square loop saturation characteristics of the tank circuit to absorb variations in average input voltage.

 

WHY YOU NEED CONSTANT VOLTAGE TRANSFORMER OR REGULATOR
Electronics instruments, Machines, Computers and other microprocessor based equipment are designed to operate on steady stream sine wave of 220/230 V RMS. The nature of utility power is such that very frequently the equipment encounter electrical disturbances and voltages which are beyond the range of those equipment. The quality of power has deteriorated so much during the past several years that today it is impossible to work without encountering disturbances. Equipment using microprocessors are especially vulnerable due to the degradation of the utility power.

 

The equipment when plugged into the wall socket outlet are normally located a good distance from the building service center ie. The place where the power meters are located.

 

Thus in order to reach the equipment potentially damaging impulses generated outside your location travel through the impedances of lot of copper wire. Although this barrier serves to dampen out many of these disturbances the real problem occurs along the electrical path from the point the power enters your premises to your equipment. Between these points are all kinds of devices such as lifts, air conditioners, Fluorescent tube chokes, Photo copiers and in case of factories the machines. Any equipment that arcs, cycle on off, or draws excessive bursts of current becomes the cause of potential hazard to your micro processor based equipment.

 

The utility power has also been so much overloaded that the demand far exceeds the supply. Coupled with that is the fact that although the wiring in your area 1 building/location was initially designed to handle lets say "x" amount of power the actual power being handled by these wires could be as much as "3x" on the top of this is the poor / negligible / nil maintenance of the junction boxes located near your premises. All this results in either very low voltages during peak load hours and very high voltages during off load hours. Microprocessor based equipment are normally designed to operate on very narrow voltage bands and when they are subject to large variation in voltages they get damaged.

 

The Solution :
Purevolt's Constant Voltage Regulators has been designed to give you total protection against power related problems and to condition the power to suit the needs of your microprocessor based equipment. Constant Voltage Regulators effectively regulates voltage variation, suppresses transients (ISOLATION) and bridges the short interruptions/dips.

Other Products Range

1 PHASE ISOLATION TRANSFORMER
Read more...
Highlights CVT
Read more...
IGBT Based
Read more...

Send Email / SMS Enquiry

WHY CONSTANT VOLTAGE REGULATOR

Get In Touch